Mostrar el registro sencillo del ítem

dc.contributor.advisorFuentes Gandara, Fabio Armandospa
dc.contributor.authorCaro Gaviria, María Esterspa
dc.date.accessioned2018-11-03T15:41:26Z
dc.date.available2018-11-03T15:41:26Z
dc.date.issued2017-10-11
dc.identifier.urihttp://hdl.handle.net/11323/243spa
dc.description.abstractEl desarrollo de un prototipo funcional tipo filtro, propuesto en el presente documento, está constituido por un sistema instaurado para filtrar y depurar aguas grises para que posteriormente puedan ser utilizadas en el sector agrícola, en la presente investigación se construyó e implemento el filtro analizando el agua resultante con la evaluación de algunos parámetros como pH, Conductividad, Salinidad, Alcalinidad, Fosfatos, Detergente, DQO y DBO5. Los materiales utilizados para la construcción del filtro fueron una botella de plástico, arena, carbón activado, gravilla, algodón y guata. Posteriormente se realizó una caracterización de las aguas influentes y efluentes utilizadas en el prototipo, recolectando muestras de agua domésticas a las cuales se le determinó algunos parámetros físicos químicos como son pH, conductividad, salinidad, alcalinidad, detergentes, fosfatos, demanda química de oxigeno (DQO) y demanda bioquímica de oxigeno (DBO5). Los resultados promedio obtenidos después de caracterizar el agua gris filtrada mostraron un pH de 5.46 unidades, la conductividad presentó un valor promedio de 3350 µS/cm, la salinidad estuvo 2.3 ppt, la alcalinidad fue de 1020 mg CaCO3/L, los fosfatos conservaron un nivel cercano a 1.06 mg Ptotal/L, la concentración de detergentes estuvo aproximadamente en 2.82 mg/L, la DQO disminuyo a un valor cercano a 292 mg O/L y la DBO5 se redujo alrededor de 160.33 mg O/L. Con este proyecto se pudo concluir que el filtro construido es una herramienta que puede ser utilizada en el sector agrícola, debido a la alta capacidad de remoción en algunos de los parámetros determinados entre los cuales destacaron la DQO y DBO5 con altos niveles de remoción con porcentajes de 80 y 88 % respectivamente; además teniendo en cuenta las variaciones de las muestras analizadas también se logró establecer que el agua gris filtrada fue la que mostro un mejor comportamientospa
dc.description.abstractThe development of a functional prototype type filter, proposed in this document, is constituted by a system installed to filter and purify gray water so that later it can be used in the agricultural sector, in the present investigation the filter was built and implemented analyzing the water resulting from the evaluation of some parameters such as pH, Conductivity, Salinity, Alkalinity, Phosphates, Detergent, COD and BOD5. The materials used for the construction of the filter were a plastic bottle, sand, activated carbon, gravel, cotton and wadding. Subsequently, a characterization of the influent and effluent waters used in the prototype was carried out, collecting domestic water samples to which certain physical chemical parameters were determined such as pH, conductivity, salinity, alkalinity, detergents, phosphates, chemical oxygen demand (COD) and biochemical oxygen demand (BOD5). The average results obtained after characterizing the filtered gray water showed a pH of 5.46 units, the conductivity presented an average value of 3350 μS / cm, the salinity was 2.3 ppt, the alkalinity was 1020 mg CaCO3 / L, the phosphates conserved a level close to 1.06 mg Ptotal / L, the detergent concentration was approximately 2.82 mg / L, the COD decreased to a value close to 292 mg O / L and the BOD5 was reduced around 160.33 mg O / L. With this project it was possible to conclude that the built filter is a tool that can be used in the agricultural sector, due to the high removal capacity in some of the parameters determined among which the COD and BOD5 with high levels of removal with percentages stood out of 80 and 88% respectively; also taking into account the variations of the samples analyzed it was also possible to establish that the filtered gray water was the one that showed a better behavior.eng
dc.language.isospa
dc.rightsAtribución – No comercial – Compartir igualspa
dc.subjectFiltroeng
dc.subjectaguas griseseng
dc.subjectagrícolaeng
dc.subjectguataeng
dc.titleDesarrollo y validación de un prototipo funcional tipo bio-filtro para la reutilización de aguas residuales domésticas en el sector agrícolaeng
dc.typeTrabajo de grado - Pregradospa
dc.contributor.coasesorAlcázar Franco, Danielspa
dc.rights.accessrightsinfo:eu-repo/semantics/openAccessspa
dc.identifier.instnameCorporación Universidad de la Costaspa
dc.identifier.reponameREDICUC - Repositorio CUCspa
dc.identifier.repourlhttps://repositorio.cuc.edu.co/spa
dc.publisher.programIngeniería Ambientalspa
dc.type.coarhttp://purl.org/coar/resource_type/c_7a1fspa
dc.type.contentTextspa
dc.type.driverinfo:eu-repo/semantics/bachelorThesisspa
dc.type.redcolhttp://purl.org/redcol/resource_type/TPspa
dc.type.versioninfo:eu-repo/semantics/acceptedVersionspa
dc.type.coarversionhttp://purl.org/coar/version/c_ab4af688f83e57aaspa
dc.rights.coarhttp://purl.org/coar/access_right/c_abf2spa


Ficheros en el ítem

Thumbnail

Este ítem aparece en la(s) siguiente(s) colección(ones)

Mostrar el registro sencillo del ítem