Show simple item record

dc.creatorJiménez-Cabas, Javier
dc.creatorTorres, Lizeth
dc.creatorLópez Estrada, Francisco Ronay
dc.creatorDE LOS SANTOS RUIZ, ILDEBERTO
dc.creatorManrique-Morelos, Fabián
dc.date.accessioned2020-11-10T20:48:48Z
dc.date.available2020-11-10T20:48:48Z
dc.date.issued2020-06
dc.identifier.issn0453-2198
dc.identifier.urihttps://hdl.handle.net/11323/7238
dc.description.abstractThis paper presents a novel non-invasive monitoring method, based on a Liénard-type model (LTM) to diagnose single and sequential leaks in liquid pipelines. The LTM describes the fluid behavior in a pipeline and is given only in terms of the flow rate. Our method was conceived to be applied in pipelines mono-instrumented with flowmeters or in conjunction with pressure sensors that are temporarily unavailable. The approach conception starts with the discretization of the LTM spatial domain into a prescribed number of sections. Such discretization is performed to obtain a lumped model capable of providing a solution (an internal flow rate) for every section. From this lumped model, a set of algebraic equations (known as residuals) are deduced as the difference between the internal discrete flows and the nominal flow (the mean of the flow rate calculated before the leak). Once the residuals are calculated a principal component analysis (PCA) is carried out to detect a leak occurrence. In the presence of a leak, the residual closest to zero will indicate the section where a leak is occurring. Some simulation-based tests in PipelineStudio® and experimental tests in a lab-pipeline illustrating the suitability of our method are shown at the end of this article.spa
dc.format.mimetypeapplication/pdfspa
dc.language.isoengspa
dc.publisherCorporación Universidad de la Costaspa
dc.rightsCC0 1.0 Universal*
dc.rights.urihttp://creativecommons.org/publicdomain/zero/1.0/*
dc.sourceTechnology Reports of Kansai Universityspa
dc.subjectLeak diagnosis in pipelinesspa
dc.subjectNon-invasive monitoring methodspa
dc.subjectLiénard-type modelspa
dc.titleDevelopment of non-invasive monitoring approach to diagnose leaks in liquid pipelinesspa
dc.typearticlespa
dcterms.references[1] R. P. API, “1130: Computational Pipeline Monitoring for Liquids.” American petroleum institute, 2007.spa
dcterms.references[2] C. Sandberg, J. Holmes, K. McCoy, and H. Koppitsch, “The application of a continuous leak detection system to pipelines and associated equipment,” IEEE Trans. Ind. Appl., vol. 25, no. 5, pp. 906–909, 1989.spa
dcterms.references[3] W. J. Reddy III, “Capacitance measuring circuit and method for liquid leak detection by measuring charging time.” Google Patents, 1992.spa
dcterms.references[4] R. K. Miller et al., “The development of acoustic emission for leak detection and location in liquidfilled, buried pipelines,” in Acoustic Emission: Standards and Technology Update, ASTM International, 1999.spa
dcterms.references[5] J. Campuzano-Cervantes, F. Meléndez-Pertuz, B. Núñez-Perez, and J. Simancas-Garc\’\ia, “Sistema de Monitoreo Electrónico de Desplazamiento de Tubos de Extensión para Junta Expansiva,” Rev. Iberoam. Automática e Informática Ind. RIAI, vol. 14, no. 3, pp. 268–278, 2017.spa
dcterms.references[6] S. R. Reddy, “System and method for detecting leaks in a vapor handling system.” Google Patents, 1993.spa
dcterms.references[7] V. V Spirin, M. G. Shlyagin, S. V Miridonov, F. J. M. Jimenez, and R. M. L. Gutierrez, “Fiber Bragg grating sensor for petroleum hydrocarbon leak detection,” Opt. Lasers Eng., vol. 32, no. 5, pp. 497– 503, 1999.spa
dcterms.references[8] N. Kasai, C. Tsuchiya, T. Fukuda, K. Sekine, T. Sano, and T. Takehana, “Propane gas leak detection by infrared absorption using carbon infrared emitter and infrared camera,” NDT E Int., vol. 44, no. 1, pp. 57–60, 2011.spa
dcterms.references[9] C. Verde, “Multi-leak detection and isolation in fluid pipelines,” Control Eng. Pract., vol. 9, no. 6, pp. 673–682, 2001.spa
dcterms.references[10] L. Torres, G. Besancon, and D. Georges, “A collocation model for water-hammer dynamics with application to leak detection,” in Decision and Control, 2008. CDC 2008. 47th IEEE Conference on, 2008, pp. 3890–3894, doi: 10.1109/CDC.2008.4739304.spa
dcterms.references[11] S. Verde, Cristina and Visairo, Nancy and Gentil, “Two leaks Isolation in a pipeline by transient response,” Adv. Water Resour., vol. 30, no. 8, pp. 1711--1721, 2007.spa
dcterms.references[12] J. Jiménez, L. Torres, I. Rubio, and M. Sanjuan, “Auxiliary Signal Design and Liénard-type Models for Identifying Pipeline Parameters,” in Modeling and Monitoring of Pipelines and Networks, Springer, 2017, pp. 99–124.spa
dcterms.references[13] J. Jiménez, L. Torres, C. Verde, and M. Sanjuán, “Friction estimation of pipelines with extractions by using state observers,” IFAC-PapersOnLine, vol. 50, no. 1, pp. 5361–5366, 2017.spa
dcterms.references[14] N. R. Bellahsene, M. Mostefai, and E. K. A. Oum, “Extended Kalman observer based sensor fault detection.,” Int. J. Electr. Comput. Eng. (2088- 8708), vol. 9, no. 3, 2019.spa
dcterms.references[15] M. Brunone, Bruno and Ferrante, “Detecting leaks in pressurised pipes by means of transients,” J. Hydraul. Res., vol. 39, no. 5, pp. 539–547, 2001.spa
dcterms.references[16] B. W. Colombo, Andrew F and Lee, Pedro and Karney, “A selective literature review of transientbased leak detection methods,” J. Hydro-environment Res., vol. 2, no. 4, pp. 212–227, 2009.spa
dcterms.references[17] U.S. Department of Transportation, “Pipeline and Hazardous Materials Safety Administration: Pipeline Significant Incident 20 Year Trend.” 2019.spa
dcterms.references[18] J. C. P. Liou, “Leak detection by mass balance effective for Norman wells line,” Oil gas J., vol. 94, no. 17, 1996.spa
dcterms.references[19] J. C. P. Lion, “Leak Detection: A Transient Flow Simulation Approach,” in Pipeline Engineering AME Petroleum Division Publication PD V60, 1994 Proceedings of the Energy Source Technology Conference, 1995.spa
dcterms.references[20] P. Ostapkowicz, “Leak detection in liquid transmission pipelines using simplified pressure analysis techniques employing a minimum of standard and non-standard measuring devices,” Eng. Struct., vol. 113, pp. 194–205, 2016.spa
dcterms.references[21] R. A. Silva, C. M. Buiatti, S. L. Cruz, and J. A. F. R. Pereira, “Pressure wave behaviour and leak detection in pipelines,” Comput. Chem. Eng., vol. 20, pp. S491--S496, 1996.spa
dcterms.references[22] E. Farmer, “System for monitoring pipelines.” Google Patents, 1989.spa
dcterms.references[23] R. Isermann, “Process fault detection based on modeling and estimation methods-A survey,” automatica, vol. 20, no. 4, pp. 387–404, 1984.spa
dcterms.references[24] L. Billmann and R. Isermann, “Leak detection methods for pipelines,” Automatica, vol. 23, no. 3, pp. 381–385, 1987.spa
dcterms.references[25] L. Torres, G. Besançon, and C. Verde, “Liénard type model of fluid flow in pipelines: Application to estimation,” in 12th International Conference on Electrical Engineering, Computing Science and Automatic Control (CCE), 2015, pp. 1–6.spa
dcterms.references[26] L. Torres, J. A. D. Aguiñaga, G. Besançon, C. Verde, and O. Begovich, “Equivalent Liénard-type models for a fluid transmission line,” Comptes Rendus Mécanique, 2016.spa
dcterms.references[27] M. H. Chaudhry, Applied Hydraulic Transients. Springer New York, 2013.spa
dcterms.references[28] J. Jimenez Cabas and J. D. Ruiz Ariza, “Modeling and Simulation of a Pipeline Transportation Process,” vol. 13, no. 9, 2018.spa
dcterms.references[29] A. C. Yunus and J. M. Cimbala, “Fluid mechanics fundamentals and applications,” McGraw-Hill Publ., 2006.spa
dcterms.references[30] L. F. Moody, “Friction factors for pipe flow,” Trans Asme, vol. 66, pp. 671–684, 1944.spa
dcterms.references[31] D. Brkić, “Review of explicit approximations to the Colebrook relation for flow friction,” J. Pet. Sci. Eng., vol. 77, no. 1, pp. 34–48, 2011.spa
dcterms.references[32] J. Jiménez, L. Torres, C. Verde, and M. Sanjuán, “Friction estimation of pipelines with extractions by using state observers,” IFAC-PapersOnLine, vol. 50, no. 1, 2017, doi: 10.1016/j.ifacol.2017.08.942.spa
dcterms.references[33] J. Jiménez-Cabas, E. Romero-Fandiño, L. Torres, M. Sanjuan, and F. R. López-Estrada, “Localization of Leaks in Water Distribution Networks using Flow Readings,” IFAC-PapersOnLine, vol. 51, no. 24, pp. 922–928, 2018.spa
dcterms.references[34] L. Torres, J. A. D. Aguiñaga, G. Besançon, C. Verde, and O. Begovich, “Equivalent Li{é}nard-type models for a fluid transmission line,” Comptes Rendus M{é}canique, vol. 344, no. 8, pp. 582–595, 2016.spa
dcterms.references[35] I. Portnoy, K. Melendez, H. Pinzon, and M. Sanjuan, “An improved weighted recursive PCA algorithm for adaptive fault detection,” Control Eng. Pract., vol. 50, pp. 69–83, 2016.spa
dcterms.references[36] J. E. Jackson and G. S. Mudholkar, “Control procedures for residuals associated with principal component analysis,” Technometrics, vol. 21, no. 3, pp. 341–349, 1979.spa
dcterms.references[37] W. R. Zwick and W. F. Velicer, “Comparison of five rules for determining the number of components to retain.,” Psychol. Bull., vol. 99, no. 3, p. 432, 1986.spa
dc.source.urlhttps://www.researchgate.net/publication/343615641_Development_of_Non-Invasive_Monitoring_Approach_to_Diagnose_Leaks_in_Liquid_Pipelinesspa
dc.rights.accessrightsinfo:eu-repo/semantics/openAccessspa
dc.type.hasversioninfo:eu-repo/semantics/publishedVersionspa


Files in this item

Thumbnail
Thumbnail

This item appears in the following Collection(s)

Show simple item record

CC0 1.0 Universal
Except where otherwise noted, this item's license is described as CC0 1.0 Universal